Section: Linux Programmer's Manual (2)
Return to Main Contents
iopl - change I/O privilege level
int iopl(int level);
changes the I/O privilege level of the calling process, as specified in
This call is necessary to allow 8514-compatible X servers to run under
Since these X servers require access to all 65536 I/O ports, the
call is not sufficient.
In addition to granting unrestricted I/O port access, running at a higher
I/O privilege level also allows the process to disable interrupts.
This will probably crash the system, and is not recommended.
Permissions are inherited by
The I/O privilege level for a normal process is 0.
This call is mostly for the i386 architecture.
On many other architectures it does not exist or will always
return an error.
On success, zero is returned.
On error, -1 is returned, and
is set appropriately.
is greater than 3.
This call is unimplemented.
The calling process has insufficient privilege to call
capability is required.
is Linux-specific and should not be used in processes
intended to be portable.
Libc5 treats it as a system call and has a prototype in
Glibc1 does not have a prototype.
Glibc2 has a prototype both in
Avoid the latter, it is available on i386 only.
This page is part of release 3.27 of the Linux
A description of the project,
and information about reporting bugs,
can be found at
- RETURN VALUE
- CONFORMING TO
- SEE ALSO
This document was created by
using the manual pages.
Time: 19:49:18 GMT, April 27, 2011